.:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2334001
Butterfly Trainer Comb by Squeezyfrog is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

This a design I found off Tinkercad and I made a few tweaks of my own.
In order to put together you will need to take the bigger pins inside the bottom of a pair of handles the smaller pins go into the top where the comb/blade will go. Remember to keep the little indents on the right side where the comb/blade has a small cylinder sticking out. After, you see that the comb has 4 tiny holes in each handle, in the real thing those are for less weight, but I put Q-tips in them to stop the comb/blade from getting through and I put some duct-tape(gorilla-tape is the one I use) on top of each comb.

Here is the original design that I found off tinkercad: https://www.tinkercad.com/things/jRyLQvaQC6I-csgo-butterfly-comb

# Custom Section

![Alt text](https://cdn.thingiverse.com/assets/fd/75/85/61/c7/IMG_4042.JPG)
Finished Thing

![Alt text](https://cdn.thingiverse.com/assets/0c/dd/4c/29/c0/IMG_4041.JPG)
Just Printed Thing